mam problem z Nanostation loco M5, po podłączeniu się przez konwerter TTL i wgraniu nowego firmware przez tftp, system wisi na Booting. Brak jakiejkolwiek komunikacji z loco.
Cytat
-
Receiving file from 192.168.1.10:53439
Received 6896765 bytes
Firmware Version: XM.ar7240.v5.5.6.17762.130528.1755
Setting U-Boot environment variables
Un-Protected 1 sectors
Erasing Flash.... done
Erased 1 sectors
Writing to Flash... done
Protected 1 sectors
Will not overwrite u-boot partition! Skipped.
Copying partition 'kernel' to flash memory:
erasing range 0x9F050000..0x9F14FFFF: ................ done
Erased 16 sectors
writing to address 0x9f050000, length 0x00100000 ...
Copying partition 'rootfs' to flash memory:
erasing range 0x9F150000..0x9F6AFFFF: ...................................................................................... done
Erased 86 sectors
writing to address 0x9f150000, length 0x00560000 ...
Firmware update complete.
Resetting...
U-Boot 1.1.4.2-s594 (Dec 5 2012 - 15:23:07)
Board not calibrated, cannot determine board type.
Board: Ubiquiti Networks XM board (rev 1.255 ffff)
DRAM: 32 MB
Flash: 8 MB
Board not calibrated, cannot determine board type.
PCIe WLAN Module found (#1).
Net: eth0, eth1
Hit any key to stop autoboot: 0
## Booting image at 9f050000 ...
Image Name: MIPS Ubiquiti Linux-2.6.32.54
Created: 2013-05-28 14:56:15 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1047584 Bytes = 1023 kB
Load Address: 80002000
Entry Point: 80002000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting kernel ...
Booting...
Asus RT-N16 [B4] Tomato v1.28 K26 USB K26 123 EN-AIO